Farmall & IHC Tractors Discussion Board |
Need help with SC Touch Control
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by MM_TX on June 21, 2006 at 17:52:17 from (69.152.253.143):
I've got 2 units off dead Super Cs that had fluid in them. On the 1st unit I can push the pistons in and out with hard resistance, but the control valves leak. The 2nd unit the pistons are not frozen (they will "give" and rotate but I cannot push them in or out even trying with different control valve positions. Question 1: Which one would be more likely to be any good without rebuilding? Question 2: If the 2nd one is just indicating better preasure how can I move the pistons so I can get the connecting rod pins in as the rods are in each others way? Thanks for any advice_mm.
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|