Farmall & IHC Tractors Discussion Board |
Re: Farmall 230 engine rebuilding questions???
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Shaggy on June 18, 2006 at 07:01:46 from (12.240.5.94):
In Reply to: Re: Farmall 230 engine rebuilding questions??? posted by Stan(VA). on June 18, 2006 at 05:36:19:
Well my Super A is a 52 and it had the 3 in bore sleeves and they were thick wall. Now it has the 3 1/4 sleeves in it and the block didn"t need any machine work done to it. It already had the 3 7/16 hole in the bottom of the block. You can have the block bored to the 3 7/16 size but then you need to take some time and do some fitting with the O rings so they fit in the block. I picked up my sleeve kit thru a Tisco dealer.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|