Farmall & IHC Tractors Discussion Board |
Re: S/N For M with HD Timing Gears
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CNKS on June 16, 2006 at 12:15:04 from (204.249.178.138):
In Reply to: S/N For M with HD Timing Gears posted by Dan Bear Kelley on June 16, 2006 at 10:48:15:
I have read on this forum that the later ones had SM gears, but my parts book does not indicate that -- no SN break. My book would have later numbers in it as it was printed in March 1960. It could be that the old gears were discontinued when the new ones came out, thus there is no need for a SN break. However the gear numbers in my book have the D suffix. Newer parts had the R suffix after 1945. Thus my conclusion (subject to correction) is that there were no SM gears in the later M's. If there were they would have been in the very late ones, shortly before the SM came out. If your M has the original engine (chassis and engine serials do not match) it makes your M about a 1950.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|