|
Farmall & IHC Tractors Discussion Board |
Still no Spark !! I'm out of ideas
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by ICRed on June 14, 2006 at 17:43:02 from (66.227.165.3):
After rewiring my Super C to the one wire diagram that Bob Melville was kind enough to e-mail, I now have lights, and my ammeter is working. But, I still have no spark on number one cylinder. I have what looks like 12 volts going to the positive side of my coil, but nothing else, and the coil still gets a little warm after cranking it a few times. I have replaced the coil thinking it could be bad, checked my grounds to make sure I have bare metal contact, pulled the coil wire to the distributor and cranked it to see if there was spark but still nothing. Infact, no spark on any cylinders. Would this new Pertronic electronic ignition I just installed have anything to do with this? I hate fooling with electrical! This project is completely done other than this, been working on this restoration project on and off since last Christmas and my 10 acre back yard is now up to my knees! I'm close to finding a roving mechanic and let him finish it. Any other suggestions?
Replies:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
