Farmall & IHC Tractors Discussion Board |
Re: 1568 T/A questions
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the tractor vet on June 14, 2006 at 17:40:49 from (64.179.117.76):
In Reply to: 1568 T/A questions posted by crg1978 on June 14, 2006 at 17:27:28:
Well i sold Hy Cap for 19 years and befor i chose one brand i did alot of asken and resurch and that is why i chose Hy Cap . I never had a come back and all the ones i installed are still in the field worken so you chose . If it is installed as per instructions it will last a long time and on your tractor i would go with the HD unit it is reasionable in price and it will stand up . Now is the time to do it wright with a new clutch and pressure plate and all new bearings and take a good look at the PTO input shaft and the bearing and if it is so so then replace it at that time . If you have any questions then i can walk ya thru the whole thing with all the set up . Oh yea install a new MCV pump and get a MCV spring kit and seal and gskt pkg . And you will need to get a hyd fitting to go into the bottom plug on the MCV and a hyd. gauge that will read 600 lbs to set pressure or atleast check pressure.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|