Farmall & IHC Tractors Discussion Board |
Farmall BN wiring update-John T
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by BobOHIO on June 12, 2006 at 19:38:21 from (66.153.65.98):
Wired in my 4 pole voltage regulator as you instructed using the L terminal. I still need to buy a new 6 volt battery to polarize generator and try it all out. I still have one more question regarding the amp meter. One post on the amp meter in wired to the BAT terminal on the VR. The other post on the amp meter is wired to the starter/battery. The posts on my amp meter are marked + and -. Does it matter which wire goes to which post? If backwards would it just show a discharge rather than charging? Thank you for your help.
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|