Farmall & IHC Tractors Discussion Board |
Dang Flat! OT
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Peabody on June 10, 2006 at 19:18:22 from (205.188.116.133):
Well, got the front tire remounted on the Cub today after having pulled it off THREE times to fix a hole in the tube. Had it done professionally this time, guy rubbed the burrs off the rim and put a piece of rubber "gasket" around the stem where the rim was kinda rotten. Put a boot in it. FYI, neither Bubble Gum, Slime nor Fix-A-Flat works to seal a pinhole leak on the inside of the tube (the part that contacts the rim). That stuff only works for a puncture on the WEAR SURFACE of the tire, where the centrifugal force of driving the tractor can place the goop over the leak to seal it. That tire better be up tomorrow morning!
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|