Farmall & IHC Tractors Discussion Board |
Re: 3 PT on S/M
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by River Bottom Farmer on June 10, 2006 at 08:58:19 from (205.188.116.133):
In Reply to: 3 PT on S/M posted by Lerm on June 10, 2006 at 08:40:31:
Lerm, I built my own three point hitch on my 39 H and I used two 2 1/2 inch cylinders on it and it will lift the front tires off the ground if I hook to something too heavy.I use a seven foot draw bar type mower that weighs in at around 1400 pounds and it lifts it easily, and it lifts everything else real easily too.I figuire you have around a 750 psi hydraulic system on the M so if your cylinder is big enough it will most likely lift it unless your hydraulics are weak.Do you use the hydraulics for anything else?Just wondering if you had a way to tell how your pump was putting out as far as pressure goes....RBF
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|