Farmall & IHC Tractors Discussion Board |
Re: super c questions
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by BillWv on June 05, 2006 at 16:26:05 from (129.71.136.148):
In Reply to: super c questions posted by ironfloats on June 05, 2006 at 12:42:04:
The 2pt Fast Hitch was not standard on Super C's. The biggest difference between the C and SC is probably the engine in the SC has 10 more cubic inches (113 vs. 123). There are a few small changes, some visible, some not. I don't have plans for a 3ph adapter but my SC has one installed; I can provide pictures if you want. The prongs are pretty easy to figure out; on mine, the top link mounting bracket replaces the belt drive pulley unit. The adapter works fine overall; the geometry can be a little strange with some implements, but I've used it with everything from finish mower and bush hog to carry all to turn plow. Right now my box blade is on it, and it's so handy I just leave it on. I posted a picture from some old advertising of the factory 3ph adapter. Link below. Bill
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|