Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: Super A Coil


[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]

Posted by John T on June 02, 2006 at 06:42:38 from (66.244.90.5):

In Reply to: Super A Coil posted by Steve Santini on June 01, 2006 at 22:06:50:

Steve, a typical cause (unless coil is bad) of severe coil overheating (so hot cant lay hands on) is when one uses 12 volts on a 6 volt coil with no external ballast, thereby exceeding the coils current (and heat dissipation) rating PLUS the points would burn up prematurely. I dont think the condensor is the problem, if they are bad the points burn up quicker and the sparks weaker but I dont see that as any typical cause for the coil to overcurrent or overheat !!!! Also the black exhaust smoke sounds like youre running too rich which can fastly gas foul n carbon up the plugs,,,,,,,see below

If you have a 12 volt tractor ???? and are using a 6 volt coil, it would be MUCH cheaper to simply add an external voltage dropping (12 to 6) current reducing Ballast Resistor then to buy a full 12 volt rated coil. It wires in series in the ignition circuit after the ignition switch and ahead of the coil. Ideally, the Ballast ohms rating would be near the same as the coils primary winding resistance (measured between its lil + and - terminals) and typical ballast values are from 1.5 to 2 ohms or so easily available from NAPA or Tractor Supply or Rural King or IHC etc etc.

NOTE if you opt for the more expensive 12 volt coil (so no ballast is required) be sure and get a full 12 volt rated one thats DOES NOT require any external ballast. The coils that are labeled "12 volts for use with an external ballast" are in reality just 6 volt coils, you need a full 12 volt rated NOT requiring any external ballast.

NOTE Although a coil will still fire if wired at incorrect polarity, they run warmer and not as efficient plus yield a weaker spark. If youre at Positive ground the coils + wires to the distributor while if youre at Neg ground its - wires to the distributor.

If the plugs exhibit an even flat black colored sooty appearance, thats indicative of excess unburned fuel from running the carb set too rich and/or the chokes not fully open and/or theres a restriction in the air cleaner or air inlet piping, any of which can cause her to throw exces black smoke out the stack, does yours??? A weak spark can contribute to plug fouling also. It can help if you use thermostats or shutters or other radiator air restrictiosn to keep the engine temp up to 180 and over,,,,,,,use HOTTER PLUGS,,,,,dont run the carb over rich,,,,,,keep the plugs n ignition n poin ts n condensor all up in good shape.

Let us know what happens

John T


Replies:




Add a Reply

:
:
: :

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U ... [Read Article]

Latest Ad: Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy