Farmall & IHC Tractors Discussion Board |
Re: 1086 POPS OUT OF REVERSE
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JJK on May 21, 2006 at 19:01:44 from (216.189.131.197):
In Reply to: Re: 1086 POPS OUT OF REVERSE posted by BILL GRIFFIN on May 21, 2006 at 16:15:11:
If you have to go in to replace the thrust washer the tractor needs to be split between the TA housing and the differential housing. With the side cover off to catch the parts on the shaft, the shaft is threaded and you can put a slide hammer on it, and pop it out easily. You would also want to check the shift coller and gear to make sure that they aren't wore to bad. There is also 2 different split gaskets so make sure that you would get the right one because that will make a difference on that shaft too. This problem doesn't happen every time you shift into reverse just when the gear happens to be in the right place. If you have any other Q's for me this week you can call me at work. Fergus International, 1-800-627-9734, and ask for Josh Kytta (pronounced Kit-ta)
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|