Posted by IHCPloughman on April 09, 2009 at 22:18:40 from (129.186.104.70):
In Reply to: Plow Questions posted by Jim Becker on April 09, 2009 at 19:44:42:
WI Dave said: (quoted from post at 02:44:42 04/10/09) There's an IH 3-16 plow for sale a few miles from my house. It needs some work, and I'd like some feedback on how much it might cost to get it field ready. The tire on the rear wheel is rotten. Will a new tire for the tail wheel be hard to find? Also, it needs 3 new plow points. The shares and moldboards are good, but the points are falling off. Are the points hard to find or extremely high priced? Last, the hydraulic ram is rusty, not real bad, though. Hopefully I explained this halfway clearly. Thanks for any help with this.
The tail wheel can be a trailer tire from your local farm supply store, $30-$60. A really nice bevelled plow tire is available from Miller Tire around $95. Inner tube (10-15).
Since you mentioned the shares are good, I assume you are looking at Plow Chief bottoms with separate points and shares. The points are available from CNH for around 90 the last time I knew. Maybe Crescent Forge and Shovel or other businesses have them. They'll probably be spendy anywhere.
As mentioned in other posts, you can adapt Super Chief throw-away lays to a Plow Chief, and then your lays are available from a farm store for $20.
If you have blacksmith shares, they are around 125 and up where you can find them new.
I guess part numbers off of moldboards would be able tell me if you have something that is exremely odd, or something that you can get parts for.
Don't have experience with rusty cylinder rods. Clean the rust off and go?
And finally, bolts and misc. hardware can add up quickly when getting an old plow field ready.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.