Farmall & IHC Tractors Discussion Board |
IH 674 3 pt not raising completely
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by dtucker21 on May 17, 2006 at 19:15:26 from (65.25.5.245):
The three point on my tractor stop raising completely. It will come up about half way and stop. I had a 7ft brushhog on it and thought that it might be too much load and tried a blade with the same result. If the implement is in the raised position and I adjust the top link the arms move, as if they are compensating. I have had the seat and cover off to replace all the bushings on the shifter size and wonder if I may have screwed something up on the right hand side while working on it. Anyone have any ideas as to why the arms go up and down as they should but do not travel as far as they should, even without any load they do not come up all the way. This is a diesel, "78 model I believe. Thanks in advance!
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|