Farmall & IHC Tractors Discussion Board |
Re: Timing a 300 utillity
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by 300Randy on May 17, 2006 at 15:56:26 from (208.44.151.58):
In Reply to: Timing a 300 utillity posted by 300Randy on May 17, 2006 at 13:25:18:
I just changed the points that where pitted pretty bad. I can't find a pointer near the fan or generator pully anywhere, maybe it got busted off years ago. Tractor runs good, just wanted to see where the timing was. I haven't had time to take it out and run it now since I put the points in but before it would run 15-20 minutes then run ruff and die.
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|