Farmall & IHC Tractors Discussion Board |
Re: Wheel seal
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by mbnok on May 16, 2006 at 22:29:13 from (216.226.31.41):
In Reply to: Wheel seal posted by Darin in Nebraska on May 16, 2006 at 09:45:41:
This won't help in the short run, but which axel do you have? The straight axel or the one with a flange that the wheel bolts to. If it is the straight axel (like a H or M)Ive cut the bolt heads off with a torch and then they (the bolts), will sometimes come out easily. If it is the flange type then you will go inside and find what keeps the axel in place like a bolt through the bull gear as on an A or B. In any case for best luck and time saving get yourself an I T manual for your tractor.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|