Farmall & IHC Tractors Discussion Board |
Oil Leak on 300U
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jenglin on April 27, 2006 at 06:05:14 from (66.43.230.89):
I recently purchased a 300U. It"s been working great, but it is starting to leak oil (only when it runs). I noticed it just the other day when it was sitting there ideling. It"s leaking up by the oil pan where the support arms for the front axel. There is a pivot ball weilded on to the support arms and it"s leaking on the front side of the support arms by the oil pan but I can"t tell for sure where. Could this be a bad gasket/seal or did I puncture it some how? Also there is a bracket that has to threaded holes in it and it is loose flopping around. One of the threaded bolts is still attached but the other is missing. How should that be attached on the pivot ball? Any suggestions are Welcome. Also, it steeres like an army tank. I about break my arms trying to use it on my acerage with or without a load. Any suggestions? Thanks
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|