Farmall & IHC Tractors Discussion Board |
Re: Old M started, now what about Oil?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by captaink on April 26, 2006 at 06:44:03 from (66.115.214.56):
In Reply to: Re: Old M started, now what about Oil? posted by Dumb Bob on April 25, 2006 at 20:37:57:
I’m guessing that the plugs you are referring to are the ones for the lift-all hydraulic pump. Sit on the tractor. The oil fill for the engine is on the right hand side between the distributor (or magneto) and the fan shroud. It is a cast cover about 2.5 inches in diameter and kind of looks like a big wing nut. The check for oil level are petcocks located on the oil pan below the frame again on the right hand side. Petcocks were standard however one may have been changed over to a dipstick, (mine was) but that dipstick is only about 5 inches long. Oil coming from the bottom petcock is enough, but should really come out the top after a fill up. A good M engine will peg the oil pressure gauge to the right (75 psi) at medium to high RPM. This is not a problem. Hope this helps.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|