Farmall & IHC Tractors Discussion Board |
Re: Well, I did it - Piston Chiseling, Part 2
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John G(TX) on April 24, 2006 at 08:27:48 from (216.136.20.34):
In Reply to: Re: Well, I did it - Piston Chiseling, Part 2 posted by Bob on April 24, 2006 at 08:17:56:
This piston was stuck harder than any I have faced before. I used a hacksaw to cut through part of it, and as the saw blade removed metal, the saw cut collapsed and pinched the blade. This happened twice in two places, so I don't think it would have come out any other way. I have heard that as aluminum pistons corrode, they expand, and sometimes can crack the sleeves. This may have happened before I got to it, and I just made it a little worse. The other three don't look nearly as bad, fairly good actually, but are still stuck tight. They are soaking right now, and I will get back to them in a few weeks or so.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|