Farmall & IHC Tractors Discussion Board |
Re: Clutch adjustment H
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Johann on April 23, 2006 at 14:02:10 from (65.114.81.83):
In Reply to: Re: Clutch adjustment H posted by Michael Soldan on April 23, 2006 at 10:22:03:
Mike, We used 3 of the bolts that attach the cover plate to the flywheel to compress everything so putting the flywheel and coverplate assembly together would be easier. We then attatched the plate to the flywheel, removed the three compressing bolts and put them in place on the outer edge of the coverplate /flywheel. There is a bolt with a nut on each of the clutch fingers. Is this where the finger adjustment is made? If so, which way do you turn it and can I mess anything up that I haven't alr4eady done. More advice please. Thanks.
Replies:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|