Farmall & IHC Tractors Discussion Board |
Re: Best way to chisel out a piston
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JT on April 19, 2006 at 08:34:58 from (70.226.211.118):
In Reply to: Best way to chisel out a piston posted by JohnG(TX) on April 18, 2006 at 08:54:48:
My M had a stuck piston also, I took a chain and made a sling across frame of tractor hanging down, put a 2 X 2 up in the piston, took a hydraulic jack, set it in the sling, then put the 2 X 2 on the jack and SLOWLY raised the jack, centering all in chains, This will push the piston and cylinder out at one time.
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|