Farmall & IHC Tractors Discussion Board |
Re: farmall H still wont start
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Charlie M on April 16, 2006 at 17:04:33 from (65.37.82.45):
In Reply to: farmall H still wont start posted by jdo on April 16, 2006 at 16:56:55:
If you've had the mag off its possible its 180 degrees off. To find out, remove the spark plugs and put you finger in the hold to plug it. As you turn the engine over by hand when the piston comes up on the compression stroke it will blow past your finger. Shine a flash light into the cylinder and watch for the pistion to reach the full stroke. At that point remove the cap on the mag and see if the roter is ready to point to number one spark plug wire. If its pointing to #3 your off 180 degrees. If the mag is attached OK connect it to a spark plug and see if you have spark. It may just need a new set of points and condenser.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|