Farmall & IHC Tractors Discussion Board |
Re: Firecrater piston questions
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by ChadS on April 14, 2006 at 07:18:51 from (66.228.96.144):
In Reply to: Re: Firecrater piston questions posted by the tractor vet on April 13, 2006 at 18:14:41:
Watch the piston to head clearence on this setup,,, I dont know about the H kit with firecraters, but the Super H with firecraters,, with the older H gas heads, the pistons hit the head. I had to grind a section out of the combustion chamber on the manifold side, to a replica of the SH-350 head compression chamber. There is plenty of meat to remove in this area, it dont take much, maybe a swipe about 3/4 inch wide, and at an angle. You can do it with a 4 inch hand grinder. If you have trouble with it, I have pictures of what I have done to make it work. Just hollar back, will email, or post it here. Chad
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|