Farmall & IHC Tractors Discussion Board |
can someone tell me how to bleed hydrolics?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by booe on April 12, 2006 at 16:06:12 from (12.74.56.225):
i have an old farmall m and i am not having any luck getting a john deer bucket to lift with it. the hydrolic fluid was pretty low so i filled it up with hydrolic fluid and then it still didnt do anything. it will move it out maybe an inch and then just quit. and if i take the cylinders loose and raise them the left one goes out fairly fast and is really really hard to push the piston back in but the right one goes out slow and is really easy to push back in. so i was told by a good friend of mine at a ih dealer to drain out that oil because regular hydrolic fluid is too thin and to just put strait 30weight in it. so i did but i am sure i have air in the lines. so is there anyway i can bleed the system? thanks alot!!
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|