Farmall & IHC Tractors Discussion Board |
Re: Seized H engine
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on April 05, 2006 at 17:24:04 from (199.17.6.136):
In Reply to: Seized H engine posted by L Collins on April 05, 2006 at 15:54:07:
The pattern for shfting is: R 2 4 N 1 3 5 Put it in 5th (right and toward you in the seat) Rocking the wheel means violently moving the top of the tire forward and back against the point at which it stops. This bump loads the engine through the drive line. Looking into the cylinders with a bore scope (gun tool) or other viewing method will also provide info that lets you know to pull it apart and fix what is stuck. If one cylinder (or more) will not fill up with fluid (holding most of the fluid for at least an hour), there is no chance it can be freed, pull it apart. Good luck. Tractor "diving" requires willingness to get really dirty. If it has been out in the rain/cold, for years, it will require a teardown. JimN
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|