Farmall & IHC Tractors Discussion Board |
Re: farmall m no bucket lifting power?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Nat 2 on April 05, 2006 at 05:45:02 from (64.80.108.52):
In Reply to: farmall m no bucket lifting power? posted by Booe on April 04, 2006 at 18:16:04:
First off, make sure the hydraulic fluid is topped off. The worst thing you can do is run the hydraulics without enough oil. You'll burn the pump up in seconds, making things worse. Second off, the hydraulics are not live. Your foot must be off the clutch pedal, or they don't work. Third off, there is a lever on the side of the tractor that controls hydraulic pressure to the box with the lever on it. This must be pulled back and locked into position. If that doesn't make it work, there are any number of possible problems. It may be as simple as the driveshaft for the belly pump is missing. All you can do is start taking things apart until you find what's broken, and do whatever it takes to fix it. As far as the belt pulley goes, there should be a lever on top of the gearbox, under the gas tank, to engage the gears that drive the pulley. The lever should have a control rod running back to the operator, but it may not. The lever may also be broken off the top of the gearbox. To operate the belt pulley, push the clutch, move the lever, then gently let out the clutch. If this doesn't work, something is broken. All you can do is start taking things apart until you find what's broken, and do whatever it takes to fix it.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|