Farmall & IHC Tractors Discussion Board |
Re: 706 hydralics
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Nat 2 on March 28, 2006 at 13:54:29 from (64.80.108.52):
In Reply to: 706 hydralics posted by butchmo on March 28, 2006 at 09:30:05:
I'm with the vet on this one: FIX THE PROBLEM. There's likely very little wrong with the valve that a little PB Blaster and a few orings won't fix. Worst case, you can get yourself a good used valve off a salvage tractor. Anything from a 706 up through a 1586 will fit, so you should have zero problems finding a good used one at a good price. You may not be able to just take out the left valve. The valves stack in from the right, as I recall, and the left valve is the last one in the stack. Unless you have a really early 706, the end cap is cast as part of the left valve. Remove the left valve, and all the hydraulic oil will come blowing out from under the seat through the open holes. You probably don't have any choice but to fix the valve.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|