Farmall & IHC Tractors Discussion Board |
Re: Setting Valves
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Ron in Nebr on March 23, 2006 at 21:15:07 from (12.192.38.163):
In Reply to: Re: Setting Valves posted by the tractor vet on March 23, 2006 at 07:24:21:
TV- if I'm the guy you were referring to, no offense taken. Funny you should mention racing though, since I got that info from a guy in NC who builds 800+ hp dirt latemodel race engines for professional racers(and has tested every possible combo and adjustment on his dyno) and it's always worked quite well for me...and I've won a good number of DLM races myself as well as having spent a number of years working on engines professionally with ASE certification in engine performance and repair... Granted, this experience was more in the automotive feild, and maybe the IH tractor engines have different cam phasing, but on most 4 cycle engines, if you set them the way I posted, the lifter for the valve you're adjusting WILL be on the base circle of the cam which is exactly where it HAS to be for an accurate setting. My post was intended only to simplify a process which could possibly be intimidating to the average old tractor owner. It's not inaccurate, it's just a faster way to do the same thing, developed and used by racers who check or set their valve lash once a week or more versus once every few years. Your method is every bit as accurate(and the way I used to do it as well). People are free to use whichever they're most comfortable with.
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|