Farmall & IHC Tractors Discussion Board |
Re: farmall A questions
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob on March 14, 2006 at 08:31:18 from (64.21.249.40):
In Reply to: farmall A questions posted by Bill Geer on March 14, 2006 at 06:22:37:
"1. Manusl says to torque head nuts at 65 ft-lbs.It seams I resd on here it was 85 ft-lbs. What is right?" Most folks use a higher figure than 65, to help prevent leaks. Retorque after it's run a bit. "2. I'am trying to time the mag. With #1 at tdc and rotor pointing at #1 toweron cap the lugs and drive do not line up. Did somebody change something in the mag. I have timing marks lined up on the front of engine." If the engine's timing marks are correct, the drive slot in the governor shaft will be horizontal at #1 TDC. Have you verified the rotor drive gear timing marks in the mag? http://www.cleancomputes.com/Cub/Blue%20Ribbon%20Service%20Manuals/GSS-5035%20Service%20Manual%20Magnetos/Page%2051.jpg
http://www.cleancomputes.com/Cub/Blue%20Ribbon%20Service%20Manuals/GSS-5035%20Service%20Manual%20Magnetos/Page%2052.jpg
(Left click on the images, to enlarge.) Likely, everything is OK, and you are seeing the differance between when the mag's impluse "latches" (before the mag's drive lugs are horizontal), and the instant the impulse "trips" (when the mag's drive lugs ARE horizontal). Try installing the mag, grounging the "kill" terminal to prevent ignition sparks, and possible "kickback", and note where the engine is when the mag impulse actually "trips".
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|