Farmall & IHC Tractors Discussion Board |
Re: more horse power with farmall?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by ChadS on March 03, 2006 at 07:31:51 from (66.228.96.157):
In Reply to: more horse power with farmall? posted by daniel gillegpie on March 02, 2006 at 15:29:29:
The Denny header dont work well in low rpm engines, they may help a 3500+rpm engine breathe more, but they usually screw up a stock engine. Just too much manifold for the cubic inch. Most, just cut the casting away from the intake and lose heat, thats about the most cost effective way to do it, if your good with a hand grinder, wont take long to remove that iron. if the carb cfms are set up correctly, that air naturally cools thru the venturi. Most of them that sweat around the carb flanges on a 90 degree day are very close to being right. You can run a cooler burning fuel, like Ethanol to help cool the mixture down, and run a long air cleaner tube with the filter on the end to the carb inlet. that will help keep air cooler. visit www.thetractorshop.com for more information. or email me. ChadS
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|