Farmall & IHC Tractors Discussion Board |
Re: installing a turbo on a non-turbo motor
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Blazing Bruck on February 27, 2006 at 17:42:30 from (206.40.122.54):
In Reply to: installing a turbo on a non-turbo motor posted by Brad in WI on February 26, 2006 at 22:17:57:
Adding a oil pressure feed to the turbo is the most important part of the installation. The oil does two jobs, the lesser of which is provide lubrication. MOST important is the removal of HEAT! A good rule of thumb is to make the oil return line twice the diameter of the oil supply line. This will allow for expansion of the oil do to the tremendous heat and allow for the quick removal of the heat- laden oil. The turbo shaft "floats" on a cushion of oil, so supply must be adequate. Always drop the return oil into the sump so as to dissipate heat quickly. Also, as you will be adding more air to the engine, recalibration of the injection pump usually is done to insure correct combustion temeratures at peak horsepower.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|