Farmall & IHC Tractors Discussion Board |
Re: Question for Hugh McKay
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on February 27, 2006 at 13:24:37 from (209.226.106.50):
In Reply to: Re: Question for Hugh McKay posted by Bob M on February 27, 2006 at 07:58:47:
Bob: I see where your coming from with the H or M however on SA, 100, 130 and 140 the largest port is 1/2 pipe thread. The only good way is put a large grease zerk in the small drain port, and sit there and wile the hours away pumping. The drain port on those takes the same zerk as rest of tractor. So you just take that top 1/2" plug out and wait for grease to show itself. One does tend to find this a bit boring, and heaven forbid if the Mrs. comes along twice in two consecutive hours and finds you sitting there pumping. Maybe that is what Mitch needs, the Mrs. to catch him. The funny part, if your greasing a combine or some other piece of equipment that takes more than a tube of grease, it doesn't last near as long.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|