Farmall & IHC Tractors Discussion Board |
Re: H dipstick
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CNKS on February 23, 2006 at 19:30:15 from (204.249.178.138):
In Reply to: H dipstick posted by Don Manty on February 23, 2006 at 18:33:35:
The petcocks were designed for kerosene or distillate fuel. Since it does not burn as well as gas, the excess accumulated in the oil pan. When using those fuels you were supposed to daily drain the contaminated oil down to the lower petcock and fill with new oil to the upper. Any level between the two during the day was ok. With gas it is best to fill to the upper and not let it get below the lower. Some people only add oil when it doesn't run out the lower. If you use that method, and your tractor uses any oil at all (most do use some), you will not know when the oil dropped below the lower petcock, and may actually run low on oil. For those who know how much oil their engine uses, I suppose that's ok. I have always filled to the upper petcock.
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|