Farmall & IHC Tractors Discussion Board |
Re: Looking at IH 484?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by EricB on February 20, 2006 at 05:12:44 from (216.209.84.11):
In Reply to: Looking at IH 484? posted by rk on February 19, 2006 at 11:59:53:
I picked up a 485 recently (just a bit newer) and I am very pelased with it. I understand the front end can get a bit loose. There are shims available for the pivot bearing.There is also a difficult to access grease nipple between the crankshaft pully and the front cross bar that will prevent wear on the shims. There is also a sneaky grease fitting on the clutch bearing. You have to remove the inspection plate to access it. The clutch bearing is a live bearing which turns all the time. This can give you the feel that the clutch needs adjustment. To examine clutch wear you have to remove the inspection plate. Grease and filter changes brought mine back to factory spec's on the dynamo. Nice little machine.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|