|
Farmall & IHC Tractors Discussion Board |
Tractor Rollover Safety - WF vs NF
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jmauss on February 11, 2006 at 06:55:10 from (64.198.83.226):
I've just been thinking a lot about tractor safety and rollover potential. I have a 350 Utility which, of course, has a wide front. It seems very stable, but I don't really know at what point it would roll, and I never want to find out. There is an old logging road in my woods that is grown over and has probably not been used in 30 years. I'd like to clear that road so I can get to the bottom to mow. The only way right now to get to the bottom is through the neighbors property. That works okay as he is a great neighbor (no legal access easement, just good neighbor), but I would like my own access. The road on my property is somewhat steep in spots, and I don't want to take any unnecessary chances, so I have been trying to decide if it is worth the bother to clear it. The access through the neighbor's property is more gradual. So my question is how concerned should I be about the potential of a 350 utility to roll over? I know the answer is that any tractor can roll over, and I have no intention of going beyond my comfort level, but I'm sure that most people in a rollover did not intend to go beyond their comfort level. How much better is a WF than a NF tractor from a rollover/safety perspective? I wonder if there are any statistics about the percentage of tractors that rolled, how many were NF vs WF. It seems there is a false sense of security, at least in my mind, that a WF is that much safer than a NF, but I don't know. Safety first. I would just like to get some other perspectives. Thanks. Joe
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
