Farmall & IHC Tractors Discussion Board |
Re: Farmall power
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Haas on February 10, 2006 at 13:22:35 from (12.65.19.139):
In Reply to: Farmall power posted by Randall Garner on February 10, 2006 at 07:30:52:
In the 1950s, on the farm in Missouri, all our baling was custom, as we did not have a baler. One of the people that did our baling had an IH PTO baler and a Super C. So yes, it is possible. However, my recollection is that it was all that Super C needed in low gear to run the baler and the governor was surging with each stroke of the baler. I suppose the baler was either a 45 or 46 McCormick, but I don't know for sure about that. It was not too long that we switched to a person that had a JD baler and a WD-45 AC tractor. The WD-45 had live PTO and double the HP of the super c. Took half as long to do the same baling job.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|