Re: charlynn instalation

Posted by Allan in NE on February 07, 2006 at 05:02:52 from (148.78.243.26):

In Reply to: charlynn instalation posted by tn terry t on February 06, 2006 at 20:45:16:

Terry,

That little "wedge" thingy will drive you right to the edge of your sanity. It is the correct part.

It sets in there really wacky and catty-wampus, not at all like your mind is trying to tell you how it should fit because that gauge bracket is not mounted "square to the world" in the first place.

If you're putting it on an H, use your original bracket and yes, you've got to wobble out a couple of holes for it. The trick is where to put those darned mounting holes.

It's been a couple of years ago since I did mine, but as I recall, the thick part of the wedge will end up at about the 5 o'clock position when viewed from the seat. This kicks that motor off to the right and down.

The best way I can describe it is that you have to "imagine" it's installation in your minds eye first.

The torque motor has to set in there in such a way as to clear the hood, while at the same time it has to point slightly down and over to the right to align with the front steering shaft coming back from that hole in the radiator up front.

Then, guess what? After you get the motor setting in there in such a way as to be pointing directly at that hole in the radiator , you get to cut off that front shaft to the correct length. But, it has got to be exact.

Good luck,

Allan

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]