The good zero turns will run you about 9 to 10k or more at 52"+. They are necessary if there is a lot of stuff in the way, that is trees and landscaped areas. At equal width, the zero turns will not work any faster than the SA in open space except that the zero turn does not waste as much time at ends. For wide open space the SA will do just fine. If you let the grass get deep, do not expect to get far above first gear, second at the most and you may have to double back over. If the blades get dull, it will not cut well. I use a 6-foot finishing mower behind a Ferguson 50 with a Perkins diesel to cut about 5 acres with trees and steep ditch bank but no major landscaping. It takes me about 4 to 5 hours but there is a lot of weed eater work and I only get there about every 3-weeks. Also remember that the PTO on the SA is not live. You will not be able to ease up to tight places or change direction without comming to a complete stop.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.