Farmall & IHC Tractors Discussion Board |
Re: CRACKED A SLEEVE!!! NEED HELP PLEASE!!!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the tractor vet on February 04, 2006 at 19:46:46 from (4.124.65.22):
In Reply to: CRACKED A SLEEVE!!! NEED HELP PLEASE!!! posted by Booe on February 04, 2006 at 18:55:04:
Yep i have been waiting for this Driving sleeves in is not the way it should be done and yea i know but i have done it this way for years . Well not only do stand a chance of this happening but you also wrinkel them you may not see it but if ya used a bore gauge it would show ya. The way is to press or pull them in but not before ya check the bore that it is going into with here again a BORE GAUGE from the top to the bottom and also using and inside mic. and also micing the outsides of the sleeves as they are not as close as you may think so one sleeve may be bigger and you may have one hole just a weeeeee bit smaller . So now either you will have to go to Case I H and get just one sleeve or go to like NAPA and get just one sleeve kit and have and extra piston and ring set .
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|