Farmall & IHC Tractors Discussion Board |
Re: Farmall 140 4th gear trouble
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on February 03, 2006 at 16:34:28 from (64.228.11.57):
In Reply to: Re: Farmall 140 4th gear trouble posted by CNKS on February 03, 2006 at 14:00:54:
CNKS: It's ben my experience these don't wear the end of the shift levers or the forks as bad as the larger tractors. Then it's also been my experience even within the larger tractors, loader tractors wear these parts much faster than non loader tractors. This thinking is quite reasonable as a loader tractor probably has a 100 times the shifts of a non loader tractor. I know my 300 always had a loader and we rebuilt that shift lever every 5 years. My 560 never saw loader work until it was 14 years old, and it was only after that the shift lever needed rebuilding. One other thing I should have told Hurst about, once that transmission top cover is removed on SA, 100, 130 and 140, great care must be exercised getting the forks in right place as the top is put back.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|