Re: Front end adjustment

Posted by Janicholson on January 31, 2006 at 13:32:39 from (199.17.6.175):

In Reply to: Front end adjustment posted by Erik in WI on January 31, 2006 at 13:08:04:

Soak it in your favorite juice. I like PB Blaster.
Block up one side at the point where the smaller tube comes out, but on the bigger tube. Remove clamps and pinch bolts

Put a 1.5 ton (or so) comealong between the rear axle and the front spindle as low as possible so as to twist on the axle.
Pound chisels along the split to open the end of the tube.

Apply twisting force without bending anything permanently.

Apply hammer blows around overlap area.

Apply the blue flame farie with much dancing.

JimN

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]