Farmall & IHC Tractors Discussion Board |
Re: Question For Gene Bender
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by gene bender on January 30, 2006 at 19:56:59 from (66.43.221.211):
In Reply to: Question For Gene Bender posted by Red Dave on January 30, 2006 at 17:00:11:
No sealer i do use the lube for the bearings around the top. The same stuff is used on the o-rings. The head gasket will keep them in place. I do use a cap screw and washer in a head bolt threaded hole to keep the sleeves from moving when the pistons and rings are installed in the next hole. I use the white stuff i get from NAPA for lube and use lots of it. I dont think it would hurt to seal the top ring around the sleeve with RTV or the black stuff as any excess will burn out when engine is started. I also paint the head gasket with hi-temp aluminium paint on the FEL-PRO gasket. Get them fron CAR QUEST.This is what i do and it has worked for me. Thanks for the questions always glad to help. always gene b
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|