Farmall & IHC Tractors Discussion Board |
Re: Water Filter on an 826.........more info!!!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by bermuda ken on January 24, 2006 at 05:46:00 from (71.98.10.209):
In Reply to: Water Filter on an 826 posted by Erik in WI on January 23, 2006 at 17:05:14:
If your "dealer" sold you a coolant filter kit the 300-400 series IH engines, they gave you the WRONG PARTS!!!! IH made a kit to fit the 360-414-436-466 engines. The D-358 in your 826 does not have a "kit" made for it. You need to get the individual parts instead. They are listed in the 786 parts catalog along with a good diagram showing the routing of the piping and valves. If you copy the 786 diagram your cost will be much less than the "kit" they sold to you.... (the kit you will end up using only half of the parts from......)
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|