Farmall & IHC Tractors Discussion Board |
Re: IH 239DT Rebuild Info Questions
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by P Backus on January 23, 2006 at 06:42:24 from (69.128.32.83):
In Reply to: IH 239DT Rebuild Info Questions posted by DF on January 23, 2006 at 06:12:00:
Bearing shells can be replaced in-frame without taking the crank out. You loosen the main caps enough so that the crank drops down maybe 1/16". Then take one cap off at a time and replace the shell in the cap, and push the other shell around the crank by pushing one end of it until it starts coming around. Same deal with seals. Thing is, without taking the crank out, it"s pretty tough to mic the journals to see if they"re worn or even if it"s been turned undersize. It"s easier on the rods because you can push the piston up a bit so you can mic the journal. Make sure you measure them in different places to see if they are out of round. They have TISCO rebuild kits on this website, over on the left. Paul
Replies:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|