Farmall & IHC Tractors Discussion Board |
Re: Glow Plug voltage
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Scout1 on January 22, 2006 at 11:37:49 from (207.162.169.152):
In Reply to: Re: Glow Plug voltage posted by The Red Barron on January 16, 2005 at 18:56:22:
The B414 is in series like christmas tree lights. When one goes out they all quit working until you track down the burnt one. In a nutshell battery to switch to resistor to #4 gp heavy copper wire run from #4 to #1 with a ground from #1 to water pump.(positive ground system). Now I have a question. I replaced the starter for one with the solonoid on it and took the ford style switch off, I also put an alternator with a built in regulator on it, and took off old regulator. It had a one 12volt battery system on it when I purchased it, so if I use the basic glow plug set up already on there I will be running a positive to the #4 gp and a positive ground from the #1gp(causing resistor melt down). How do I ground the system from a negative ground standpoint with this set up?
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|