Farmall & IHC Tractors Discussion Board |
Re: Brakes Swinging Draw bar
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on January 21, 2006 at 18:18:46 from (66.173.50.167):
In Reply to: Brakes Swinging Draw bar posted by BenMi on January 21, 2006 at 18:07:24:
Though we don't know which model, I will assume that the expander plate between the disks was not taken apart. There cannot be any rust or worn pockets in the ramps and three balls that wedge the plates apart. The balls and ramps can be preserved with a very light film of anti sieze to keep them working a bit longer. (some say not to put anything on them, but I think they live where it is dry) If there is more than 1/8" space between plate and end housing when assembled, Machining the outer housing may be needed to decrease to 1/16". (or a sheet steel ring could be made to fit into the end housing). Glazed surfaces will also reduce effectiveness, break the glaze with 200 grit carbide paper (both disks and Iron surfaces. JimN
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|