Farmall & IHC Tractors Discussion Board |
Re: Found the problem w/ #3 piston
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by El Toro on January 12, 2006 at 04:12:52 from (205.188.117.73):
In Reply to: Found the problem w/ #3 piston posted by Kelly C on January 11, 2006 at 14:54:52:
I had a piston that looked to be about the same shape as yours. It never missed and it had a slight clicking noise. When I removed the oil filler cap there was a lot of oil blowing out. I thought there was compression blowing into the crankcase. This was on a GM 2.5L engine. I pulled the head and there was groove worn into the cylinder wall. When I pulled that piston it had broken rings and a portion of the piston was missing. I pulled the engine and had it bored oversize. Ran like a new car after that. I restored 5 or 6 Standard Twin garden tractors and one Viking that were made in MN. This was about 30 years ago and I bought parts from American Farm Machinery in New York Mills and Ottertail MN. They used an all gear drive with a multi-disc clutch that ran in oil. When WW2 started they stopped production. The later tractors were on rubber. I never had one on rubber all were on steel. I still have the moldboard plow from one these tractors and adapted it to my Gilson Garden tractor. The hydraulics pick it up easily. That's a nice collection of tractors you have. Nice looking hay too. Hal from MD
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|