Farmall & IHC Tractors Discussion Board |
Finally, The pully is off
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by scott#2 on January 10, 2006 at 15:11:47 from (151.200.35.38):
I jusy cant figure what happened here. I went at it again after I got home with the same setup, puller and bearing seperator and it still wouldnt budge. I read all the post's that everyone left, I especially liked the one about gauling the shaft up when it went on but I knew that wasn't the case since it slide on without any problem. I grabbed the porta band and was about ready to start in on it when I thought maybe it just needs a little stress relief. So I got a drill and a 1/4" bit and drilled down to the crank, filled it with pb blaster, put the puling setup back on it and started cranking till it wouldn't crank anymore. Then I gave it a good hard smack with the sledge and it poped and moved. I will say that I had to smack and crank it all the way off. Took about a half hour of cranking and swinging to get it all the way off. I dont know what you guys think but Im gonna hone that thing out to a tight slide fit and drill another hole and thread both up for set screws. Im not going through that ever again. Any comments on my idea there??? scott#2
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|