Farmall & IHC Tractors Discussion Board |
Re: 706 rebuild 3 questions?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by captaink on January 09, 2006 at 07:35:16 from (66.115.214.56):
In Reply to: 706 rebuild 3 questions? posted by Kelly C on January 07, 2006 at 18:13:19:
Lots of good stuff here so far. One more thing on the burnt valve. When you have the valves done make sure that it has rotators on the exhaust valves and that they are working correctly. If the exhaust valve doesn't rotate then it is possible that carbon could get between the face and the seat and allow the extremely hot exhaust gas to pass through during the power cycle in the cylinder. This super-heated gas will over heat the thin outer margin of the valve possibly to the point that it will literally blow out a small portion of the valve. Once this begins, it just gets worse, eventually to the point that yours is. A burned valve left go long enough can cost you a guide (valve is always under sideways pressure when closed) and a seat if the valve guide gets loose enough to allow the valve to shift off center on the seat.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|