Farmall & IHC Tractors Discussion Board |
Re: Vibration in idling M - normal?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Randy-S.E.MN on January 08, 2006 at 07:14:03 from (206.9.216.45):
In Reply to: Vibration in idling M - normal? posted by Dan Crocker on January 08, 2006 at 05:04:53:
I have found that a bent, warped or even excessively loose drive shaft caused vibrations on a couple of my Farmalls. IH did not give precision attention to what is a precision part. They were not cast or machined very true. The center link and wedge bolts may have considerable wear. I fill all the holes and grooves with braze and hand file them back down and redrill.. every little bit helps here...Randy
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|