Farmall & IHC Tractors Discussion Board |
Re: Dished wheels and Red P M
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Nat 2 on January 05, 2006 at 05:21:03 from (64.80.108.52):
In Reply to: Re: Dished wheels and Red P M posted by Dave BN on January 04, 2006 at 22:17:23:
Nope, like others have said, they did that to fit more tractors on the rail cars, trucks, boats, etc.. When they got to their destination, the mechanic would pull the wheels off, flip them over, and slide them back on the axles. Viola! The treads are pointed in the right direction. If you want dished-in-narrow tractors, up here in Rochester, NY, they use old Farmalls to plow the sidewalks in the city. Nope, not As and Cs, which would make sense on less than 4' wide sidewalks. They use Hs and Ms, and I think they even have a few 460s and/or 560s in the fleet. Wheels dished in, slid all the way in against the axles, with TIRE CHAINS. I don't think they have fenders. Yikes.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|